The customer
A US maker of commercial beverage equipment that builds thousands of units a year, each with a DCLTEK 10.1″ touch display.
The challenge
The LCD panel maker issued an end-of-life notice on the glass inside the display.
- Production at risk. Once last-time-buy stock ran out, the line would stop.
- Redesign risk. A different panel could mean new mechanicals, new firmware and re-certification of the customer’s product.
- Hidden differences. A “replacement” part from the same maker can still change brightness, color, timing or outline in ways that only show up in production.
What DCLTEK did
- Bridged supply. Sized a last-time buy of the old cell to cover the customer’s forecast through qualification.
- Picked the successor. Compared the panel maker’s replacement cell line by line against the original: outline, interface, timing, brightness and viewing angle.
- Closed the gaps at the module level. Where the new cell differed, DCLTEK and our factory partner adjusted the module build so the customer’s interface and form factor stayed identical.
- Built and tested samples. The customer evaluated samples side by side in their product, with DCLTEK engineering supporting the test.
- Managed the cut-over. DCLTEK’s in-country team controlled the transition at the factory so old and new builds never mixed, with a clean date-code break.
The result
- Zero line-down days through the transition.
- Same DCLTEK part number, same drawings. The customer’s BOM and mechanicals did not change.
- No re-certification of the customer’s product.
- Replacement samples approved within the last-time-buy window.
- The customer’s engineering team stayed focused on new products, not on chasing a dead part.
Why it matters
Panel makers end-of-life parts on their schedule, not yours. DCLTEK watches the supply base, plans the bridge and absorbs the change inside the module, so your product keeps shipping.
Facing an end-of-life notice on a display? Talk to the team that solved this one.